(c)

brushing device. h (1) this device cists of a baseboard

over which a smaller carriage is drawn. this carriage on parallel tracks

attached to the edges of the upper surface of the baseboard. the brush is

hinged with pin hinges at the rear edge of the baseboard&rests on the

carriage vertically with a pressure of 150 grams.

h see §1610.61(c)(2) for a clarification of the brushing technique for

fabric with raised-fiber surfaces.

c 刷毛裝置。h1該裝置由一個底板組成,，可燃性,，底板上有一個較小的托架。該車廂在與底板上表面邊緣相連的平行軌道上運行,。電刷與底板后緣的銷鉸鏈鉸接,，垂直放置在托架上，銷售紡織品可燃性測試儀,，壓力為150克,。

h見§1610.61c2，了解纖維表面凸起織物的刷洗技術,。

(2)

the brush cists of two rows of stiff nylon bristles mounted with the tufts

in a staggered ition. the bristles are 0.016 inch in diameter&0.75 inch

in length. there are 20 bristles per tuft&4 tufts per inch. a clamp is

attached to the forward edge of the movable carriage to permit holding the

specimen on the carriage during the brushing operation.

刷毛裝置

2 刷子由兩排剛性尼龍刷毛組成,，刷毛交錯安裝。刷毛直徑為0.016英寸,，長度為0.75英寸,。每簇有20根鬃毛，每英寸有4根,。夾具固定在可移動托架的前邊緣,，以便在刷牙操作期間將試樣固定在托架上,。